Preamplifier for EMI / EMC Probes

Preamplifier for EMI / EMC Probes

Availability:
In Stock
$575.00
Current Stock:
Adding to cart… The item has been added
(No reviews yet)
Description

This optional amplifier is a low-noise, wide-bandwidth amplifier designed for use with the 100 series EMI / EMC probes. It features a gain of over 30 dB and a frequency response of 100 kHz to 6 GHz.

Its high gain and low noise improve the system sensitivity by 20 to 30 dB. This higher sensitivity allows the user to widen the spectrum analyzer resolution bandwidth, resulting in faster sweeps and measurements, 10,000 faster or more.

Standard 50 ohm SMA(f) inputs and outputs allow it to be used in any application requiring a low noise amplifier. RF input and output are protected against ESD and DC power. 

AC power supply is included. Probe cable or adapters are suggested to connect to probes. 

Specifications:

Gain: 32 dB

Frequency Response:  100 kHz to 6.0 GHz: +/- 1.5 dB

Noise Figure:
5 dB typical, 100 kHz to 4.0 GHz
6 dB typical, 4.0 GHz to 6.0 GHz

1 dB Output Compression Point:
+10 dBm, 100 kHz - 2 GHz
+ 5 dBm, 2 GHz - 6 GHz

Port Characteristics:
Impedance: 50 ohms nominal
Maximum Input Power: +15 dBm
Maximum DC Voltage: +/- 10 VDC
Connector: SMA female

Power:
DC power input: +9 VDC, 150 mA
Connector: DC power jack, 2mm center pin, positive center
Unversal Power supply (100-240 VAC, 50/60 Hz) included

Environmental:
Operating temperature: 0C to 55C
Storage temperature: -20C to 70C

Dimensions:
4.3" x 4.2" x 1.4"